Strict safety regulations, complex installation conditions and the lack of qualified specialists pose major challenges for door manufacturers, installers and building owners. Higher opening and closing speeds of doors and increasing demands on design are further market requirements.

ExpertSystem is BBC Bircher Smart Access’ answer to these challenges and sets new standards on the market. The sophisticated system meets a wide range of customer requirements and creates added value at the same time.

Thanks to self-assembly, plug-in connections and an optional quick-fit system, installation times and the number and duration of service calls can be significantly reduced.

The safety edge solution

System overview

ExpertSystem XL

End cap

Contact end piece with plug

Quick mounting system

ExpertSystem XRF

Radio system

DIN receiver
(XRF-RD)

Integrated transmitter
(XRF-TI)

ExpertSystem XL

Modular safety edge system for door applications

Zum Produkt

ExpertSystem XRF

Wireless signal transmission system for door applications

Zum Produkt

Technical data

Device dimensions (W × H × D)

XRF-T.2 (Transmitter): 50 × 121 × 23 mm
XRF-TI (transmitter): 18 × 194 × 18 mm
XRF-R.1 (receiver): 50 × 121 × 23 mm
XRF-R.2 (receiver): 75 × 121 × 24 mm
XRF-RD (receiver): 22.5 × 94 × 91 mm
XRF-TW (transmitter): 66 × 58 × 16 mm
XRF-TW (Magnet): 66 × 17 × 16 mm

Electrical Specifications

Frequency

868 MHz

Transmitter XRF-T.2, XRF-TW

Operating voltage: 3 V lithium battery (CR2450N)
Battery life: Typically 1.2 years

XRF-TI Transmitter

Operating voltage: 3.6 V inorganic lithium battery
Battery life: Typically 7 years

Receivers XRF-R.1, XRF-R.2, XRF-RD

Operating voltage: 12–36 V AC / 48–62 Hz
12–36 V DC
Power consumption: Max. 1 W
Outputs (redundant): 24 V AC/DC relays, 1 A
Option: 8.2 kΩ parallel resistor

General Information

Range: 100 m under optimal conditions
Protection rating: IP65 (except XRF-RD = IP20)
Certifications:
EN ISO 13849-1 (PL d, Cat. 3)
EN 300 220
EN 301 489

Note:
ExpertSystem XRF signal transmission systems are type-tested in combination with Bircher edge sensors.
Technical specifications and recommendations regarding our products are based on experience and are intended as guidelines for the user. Information in brochures and data sheets does not guarantee any specific product characteristics. This does not apply to specific product characteristics that we confirm in writing or on a case-by-case basis. We reserve the right to make changes due to technical advancements.

The advantages

The ExpertSystem is rounded off by a flexible logistics and service concept. It offers uncompromising security, scalability, efficiency and sustainability thanks to its sophisticated design.

Safe

High sensitivity ensures fast response – With the innovative profile cross-section and short activation distance, ExpertSystem responds even at very low actuating forces
Optimum design for unlimited overtravel – The increased overtravel enables the lowest possible profile height for every application
Fast response time of the entire sensor system – ExpertSystem has a large switch-active sensor surface
Selectable safety category – automatic use of the ideal safety between PLc, Cat. 2 or PLd, Cat. 3

Scalable

Sustainable

Areas of application

From a design and compliance perspective, ExpertSystem fulfills various aspects of safety and reliability with its four profile heights, versatile functions and a transmission system tailored to customer needs. This comprehensive security solution is mainly intended for perimeter protection